Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

URGENT! 6748 linecard issue

My dear respected teachers and gurus,

I've got a bit of a problem (isn;t it funny how people only call when they've got issues). I've got a 6748 line-card that is going into a 6500 chassis, but it's not recognising the card. I've tried using a SUP2 and sup2-2ge supervisor card. i cleared the previous congig in case there was a mismatch, but now i get the following:

**** buffer provided is smaller than SPROM.

**** buffer provided is smaller than SPROM.

**** buffer provided is smaller than SPROM.

**** buffer provided is smaller than SPROM.

When i type the mod command i get:

Console> (enable) sh mod 4

Mod Slot Ports Module-Type Model Sub Status

--- ---- ----- ------------------------- ------------------- --- --------

4 4 0 10/100/1000BaseT Ethernet no power-bad

and when i go to test the card i get:

Console> (enable) sh test 4

Module 4 is powered off.

The customer is coming to collect it tomorrow!! Is there anything that i can try to get it operational - we don't have TAC access (must consider that from now on)

2 REPLIES
Hall of Fame Super Blue

Re: URGENT! 6748 linecard issue

Hi

The 67xx cards for the 6500 will only work with the Supervisor 720 i'm afraid.

Jon

New Member

Re: URGENT! 6748 linecard issue

THAAAAAAANK YOUUUU!!!!!

171
Views
5
Helpful
2
Replies
CreatePlease to create content