Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Urgent config needed for HWIC 2 FE PORTS

Hi

PLease guide me on how to configure HWIC 2 FE ports(cISCO 2852 ROUTER)

the bandwidth/Speeed that are going to be terminated on this ports will 4 M and each port

Could you please any one let me know how to configure these 2 FE ports

Adhitya

5 REPLIES
Hall of Fame Super Silver

Re: Urgent config needed for HWIC 2 FE PORTS

Hello Adhitya,

this HWIC 2FE should provide two routed ports

so you just need to configure the two ports

int fas0/0

desc first link

ip address x.x.x.x 255.255.255.x

no shut

int f0/0

desc first link

ip address y.y.y.y 255.255.255.y

no shut

It is wise to add a shaper

policy-map shape_out1

class class-default

shape average 3900000

policy-map shape_out2

class class-default

shape average 3900000

int f0/0

service out shape_out1

int f0/1

service out shape_out2

other aspects may be needed but you haven't provided much detail

Hope to help

Giuseppe

New Member

Re: Urgent config needed for HWIC 2 FE PORTS

HiGiuseppe

Thanks very much for the such a quick response.we have 2 leased lines of 4 mb capacity are going to be terminated on Cisco 2851 HWIC 2 fe router, ur configuration has helped me

Please let me know what exactly more information you require

Could you please send me doc fo the same

Adhityua

Hall of Fame Super Gold

Re: Urgent config needed for HWIC 2 FE PORTS

When you bandwidth is limited by the ISP, you do not need to configure any service policy on your router.

Hall of Fame Super Silver

Re: Urgent config needed for HWIC 2 FE PORTS

Hello Adhityua,

the configuration I have provided should be enough for your needs.

a link to QoS documentation in 12.4 mainline IOS

http://www.cisco.com/en/US/docs/ios/qos/configuration/guide/reg_pkt_flow_shaping.html

I think that shaping in your case is recommended because your physical interfaces are FE with 100 Mbps capabilities but circuit speed is only 4 Mbps.

The router without shaping tries to send packets as fast as possible that is at line speed and then to stay silent.

Hope to help

Giuseppe

Hall of Fame Super Gold

Re: Urgent config needed for HWIC 2 FE PORTS

So ask SP to use 10 mbps instead, and all should be fine.

375
Views
0
Helpful
5
Replies