cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
541
Views
17
Helpful
10
Replies

URGENT CONFIG-PZ HELP!

alsayed
Level 1
Level 1

Kindly,have a look to the attached diagram!

i have 2 wireless connection from 2 different ISPs(ISPA;ISPB)ISP A Terminate link at R1;ISPB Treminate link at R2;i want to achieve the following setup:if the first Link(ISPA)fail the second link (ISPB) TAKE OVER.R1 ITS PRIMARY;R2 ITS SECONDERY.e.g continuous internet access in case on of link goes down

How can i CONFIGURE like this setup?

10xs for ur reply

10 Replies 10

ahmednaas
Level 4
Level 4

Hi Ali,

Is that an L3 switch you have there?

IT IS 3560 SWITCH;BUT THE FOCUS ON THE ROUTERS

10XS

It looks like you have to do it on the switch. The easiest way is to define 2 static routes on the switch, one to R1 and another to R2. Give the backup route a higher administrative distance.

hi

do y mean the ip route to the real ip f0/1:194.126.10.3 or to the f0/0:10.10.100.3?plz provide some config on the switch..

10xs

it goes something like this:

ip routing

ip route Lan_net Lan_mask fe0/0_R1 90

ip route Lan_net Lan_mask fe0/0_R2 120

acomiskey
Level 10
Level 10

Do you have another port on the routers to link them together. If so you could run static routing backup with object tracking on primary router.

no i have only f0/0 f0/1;any help

devang my freind Thank you;realy i appreciate each reply to my post...

HI

any reply Here!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco