Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

US customer needs 220V power for a 3845 router

Is there a US 220V power cable certified to work with the 3845 non-IP power supplies? Or, must I connect the 3845 with 110V in the US? Thanks.

1 REPLY
Gold

Re: US customer needs 220V power for a 3845 router

Your larger question should be what type of 220 circuit does the customer have.

There are a number of different plugs based on the amps and if they are locking or non locking.

For 220 you will most likely have some form of 6-xx where xx is the amp rating.

The end on the router is called a C13 so its just a matter of getting the correct ends.

Been a while since I saw a part number for a cisco cable. But this link has diagrams of 2 of the 3 more "common" 220v cables you will find in the US. Not that this is a common thing to really do.

The electrician that installed the 220 circuit for them should be able to provide a power cord.

http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/hw/installation/guide/portcabl.html

291
Views
0
Helpful
1
Replies
CreatePlease login to create content