Use a channelized T3 adapter for an unchannelized circuit
I have a PA-MC-T3 but need to use it on a full T3. Can I do that with this card? This is not the PA-MC-T3-EC which I know can switch modes.
The only way I can think of is to break out the individual T1s and then use a BVI for all 28 serial interfaces but I'm not sure if it will work. Would like a point in the right direction if someone out there has had to do this before.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...