Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Use route-reflector-client in iBGP

Hi, my doubt is the next:

Ii have the next topoly:

     R5                      R6---------R7

         \                    /

          \                  / 

           R4            R2

               \         /

                 \     /

                    R3

R4,R3 and R2 belong to the same AS 100.

R5 belong to AS 200

R6 belong to AS 300

R7 is a static route.

My problem is that i use route-refelctor-client on R4 and R2 pointing R3 and viceversa, but i cant' see the routes static from R6, i already redistribute static on R6.. How can i do, only using BGP?

2 REPLIES
New Member

Re: Use route-reflector-client in iBGP

Hi Kevin,

Can you post the bgp configuration of each routers?, posting "show ip bgp" and "show ip bgp summary"  output would also be useful..

-bava

Purple

Use route-reflector-client in iBGP

Hi,

in your topology you can use R3 as the RR and  either R4 or R2 as a RR-client with the command neighbor x.x.x.x route-reflector-client.

Let's suppose R2 is a RR-client then when R3 receives an iBGP update from R2(client) it will reflect to R4( non-client) and when it receives an iBGP update from R4(non-client) it will reflect to R2(client) due to iBGP route-reflection rules.

Regards.

Alain

Don't forget to rate helpful posts.
724
Views
0
Helpful
2
Replies
CreatePlease to create content