Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Used Cisco 7200 series missing NVRAM

We purchased a 7200 series with a c7200-i/o and rj-45 fast ethernet ports. The NVRAM chip in missing. How can I get one? Does it have to have one installed?

2 REPLIES
Cisco Employee

Re: Used Cisco 7200 series missing NVRAM

Hello,

Are you referring to NVRAM or are you referring to Flash? NVRAM is supposed to be part of the motherboard. So, if you do not have NVRAM, then I guess you need to have a different I/O module. If you do not have the Flash card, then you can buy one that is compatible (PCMCIA Card).

Regards,

NT

New Member

Re: Used Cisco 7200 series missing NVRAM

I am referring to the NVRAM that is supposed to be in the I/O card. When I connect to the console port and turn on the router I get :

System Bootstrap, Version 11.1(10) [dschwart 10], RELEASE SOFTWARE (fc1)

Copyright (c) 1994 by cisco Systems, Inc.

Warning: monitor nvram area is corrupt ... using default values

environment checksum in NVRAM failed

Warning: NVRAM size is 0

C7200 processor with 131072 Kbytes of main memory

rommon 1 >

  Configuration Summary

enabled are:

console baud: 9600

boot: the ROM Monitor

I can't get out of rommon.

813
Views
0
Helpful
2
Replies
CreatePlease login to create content