Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

user authentication

In an easy vpn scenario where asa is the server the following command on the asa enables user authentication behind the hardware client:user-authentication enable

Which username and password will users enter ? How and where do we configure them? (on the server or on the client)

2 REPLIES
Hall of Fame Super Silver

Re: user authentication

Hello Kouferidji,

in the document you attached in the other thread:

You have to enter the crypto ipsec client ezvpn xauth command which prompts you for a username and

password. This should match the username and password configured on the ASA 5520. Once the username

and password is agreed by both peers, the rest of the parameters are agreed and the IPsec VPN tunnel comes

up.

EZVPN(ASA): Pending XAuth Request, Please enter the following command:

EZVPN: crypto ipsec client ezvpn xauth

!--- Enter the crypto ipsec client ezvpn xauth command.

crypto ipsec client ezvpn xauth

Enter Username and Password.: cisco

so the username/pwd is defined on ASA but the authentication becomes interactive.

Hope to help

Giuseppe

New Member

Re: user authentication

Hello,

you are describing a hardware client authentication but that is not what i am referring to.I am talking about novice user authentication behind the hardware client.These users don't know anything and i would like to create a username/password (TO ESTABLISH VPN TUNNEL)like when authenticating in windows.

311
Views
0
Helpful
2
Replies
CreatePlease to create content