the vtys or console could also be configured with just a password on them, so also look for that. You will not be able to remote manage the router until you set up some sort of user or password method for the vty.
to set up a user:
username cisco privilege 15 secret cisco
username of cisco, password of cisco(but it's encrypted when you show run), and the highest privilege level.
on vty 0 4(optionally on con 0 and aux 0):
Once you put an ip on an interface you should be able to log in.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...