Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

using bandwith xxx and ssr-queue bandwith limit xxx together on the same interface

Hi!
We have the following configurations on some of our WAN interfaces and I'm not shure if it works, what i think it should work:

interface FastEthernet0/1
no switchport
bandwidth 6700
ip address 10.1.10.1 255.255.255.252
speed auto 10
srr-queue bandwidth share 1 70 25 5
srr-queue bandwidth shape 5 0 0 0
ssr-queue bandwidth limit 67
priority-queue out
mls qos trust dscp
storm-control broadcast level 10.00
storm-control action trap
rmon collection stats 3 owner monitor
!
interface FastEthernet0/2
no switchport
bandwidth 45000
ip address 10.1.1.1 255.255.255.252
speed 100
duplex full
srr-queue bandwidth share 1 70 25 5
srr-queue bandwidth shape 5 0 0 0
ssr-queue bandwidth limit 45
priority-queue out
mls qos trust dscp
storm-control broadcast level 10.00
storm-control action trap
rmon collection stats 3 owner monitor

On fastethernet 0/1 we have a WAN link with 6.7MBit/s. On this interface, I'm not shure if the command "speed auto 10" works with the command "ssr-queue bandwith limit 67". I think the speed meeds to be fixed while using the command "ssr-queue bandwith limit 67"

On both interfaces: does "ssr-queue bandwith limit xx" use the physical speed of the interface or the speed setwith the "bandwitdh xxx" command. With interface fa0/2 this would be 45% of 45000kBit/s = 20250kBit/s.

Thanks for any comments in advance!

Cheers Walter

Sent from Cisco Technical Support iPad App

1 REPLY
Super Bronze

Re: using bandwith xxx and ssr-queue bandwith limit xxx together

Disclaimer

The   Author of this posting offers the information contained within this   posting without consideration and with the reader's understanding that   there's no implied or expressed suitability or fitness for any purpose.   Information provided is for informational purposes only and should not   be construed as rendering professional advice of any kind. Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In   no event shall Author be liable for any damages whatsoever (including,   without limitation, damages for loss of use, data or profit) arising  out  of the use or inability to use the posting's information even if  Author  has been advised of the possibility of such damage.

Posting

My understanding is the bandwidth-limit uses the physical "speed" the interface is currently running at.

655
Views
0
Helpful
1
Replies