Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using NAT with DHCP on Wan side

Hey guys, I'm currently enrolled in the cisco networking academy through school, and I will be soon purchasing a Cisco 2600 series router to practice with at home.

I was doing some configuring on packet tracer, and was wondering if it is possible to setup NAT to provide internet access for multiple PCs on a cable internet connection (DHCP).

ip nat pool pool_name start_ip end_ip netmask a.b.c.d

From what I understand on this command is that you can only translate LAN addresses to a static WAN address.

Any help would be greatly appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Using NAT with DHCP on Wan side

Hello Steven,

you can use something like

ip nat source inside list 11 interface wan_interface_name overload

this is the typical setup the key is to use the interface name as a reference

Hope to help

Giuseppe

3 REPLIES
Hall of Fame Super Silver

Re: Using NAT with DHCP on Wan side

Hello Steven,

you can use something like

ip nat source inside list 11 interface wan_interface_name overload

this is the typical setup the key is to use the interface name as a reference

Hope to help

Giuseppe

New Member

Re: Using NAT with DHCP on Wan side

Yeah I actually JUST figured that out, while I was researching it a bit more.

Ended up using

int fa0/1

ip nat inside

int fa0/0

ip nat outside

ip nat inside source list 7 interface fa0/0 overload

access-list 7 permit 10.10.0.1 0.0.0.254

my addresses are now translating in packet tracer ^_^

Thanks.

New Member

Hello Steven,

Hello Steven,

Did you manage to get this resolved. I want to set something similar on 2911 router.

1735
Views
0
Helpful
3
Replies