I would like to set profiles on my router (6509 w/ Sup720 3BXL) to restrict outbound routes based on the source IP address. I.e. if I have three upstream providers (ISP A, B, and C) I would like to configure 10.0.0.0/24 to use ISP A and B but not C. Ideally this would be configured exclusionary (i.e. 10.0.0.0/24 not allowed via ISP C) vs. inclusionary.
All of the information that I have been able to find so far specifically Set's the next-hop (i.e. 10.0.0.0/24 next-hop equals ISP B), is there a way to do the reverse of this?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...