Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using SPAN

Can anyone tell me if I can setup a monitor session and have the source and destination ports on different blades on the same switch? The switch in question is a catalyst 4507. The documentation says it has be be on the same switch, but all the example points to it being on the same blade. Not real clear and I am just trying save myself some work and or frustration.

2 REPLIES

Re: Using SPAN

Hi,

Sure you can, check this link for

CATOS http://www.cisco.com/en/US/docs/switches/lan/catalyst4000/7.5/configuration/guide/span.html

IOS http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.1/12.1e/configuration/guide/span.html

..the source and destination in the example in "Configuring SPAN" is in different blade.

Regards,

Dandy

New Member

Re: Using SPAN

Yes, you can also use RSPAN to monitor from a remote switch.

422
Views
0
Helpful
2
Replies