05-14-2007 08:28 PM - edited 03-03-2019 04:58 PM
HI,
V WIC 1MFT G703 E1 CONTROLLER CARD,It will support 2mbps data in 1841 cisco?
KIndly confirm the config:
Config t
Controller E1 0/0/0
channel-group 0 unframed
Config t
int serial 0/0/0:0
bandwidth 2048
ip address x.x.x.x x.x.x.x
Kindly revert back
Solved! Go to Solution.
05-15-2007 04:04 AM
Another note, if you use "timeslots 1-31", you don't need the G.703 version of VWIC, but just the normal one, that is much less expensive.
The G.703 version is only needed when you absolutely need to support "unframed".
05-14-2007 08:53 PM
Hi,
Since channel-group is set to 'unframed',It will definitely support 2 mbps speed.
Please rate ,if it is useful.
--Jaffer
05-14-2007 09:11 PM
HI,
VWIC IMFT G703 EI CONTROLLER CARD ,IT WILL SUPPORT DATA?
05-14-2007 10:14 PM
Hi
I think you need to use timeslot 1-31 ,please see below command .
channel-group 0 timeslots 1-31
I hope this will help you out.
-Minu
05-15-2007 03:21 AM
There is a difference,
Channel-group 1 timeslots 1-31 is framed at 1.984 Mbps.
Channel-group 1 unframed, is 2.048 Mbps.
On an unframed circuit you can use both.
Of course all the vwic cards supports data.
05-15-2007 04:04 AM
Another note, if you use "timeslots 1-31", you don't need the G.703 version of VWIC, but just the normal one, that is much less expensive.
The G.703 version is only needed when you absolutely need to support "unframed".
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: