Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

V WIC 1MFT G703 E1 CONTROLLER CARD

HI,

V WIC 1MFT G703 E1 CONTROLLER CARD,It will support 2mbps data in 1841 cisco?

KIndly confirm the config:

Config t

Controller E1 0/0/0

channel-group 0 unframed

Config t

int serial 0/0/0:0

bandwidth 2048

ip address x.x.x.x x.x.x.x

Kindly revert back

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: V WIC 1MFT G703 E1 CONTROLLER CARD

Another note, if you use "timeslots 1-31", you don't need the G.703 version of VWIC, but just the normal one, that is much less expensive.

The G.703 version is only needed when you absolutely need to support "unframed".

5 REPLIES
New Member

Re: V WIC 1MFT G703 E1 CONTROLLER CARD

Hi,

Since channel-group is set to 'unframed',It will definitely support 2 mbps speed.

Please rate ,if it is useful.

--Jaffer

New Member

Re: V WIC 1MFT G703 E1 CONTROLLER CARD

HI,

VWIC IMFT G703 EI CONTROLLER CARD ,IT WILL SUPPORT DATA?

Bronze

Re: V WIC 1MFT G703 E1 CONTROLLER CARD

Hi

I think you need to use timeslot 1-31 ,please see below command .

channel-group 0 timeslots 1-31

I hope this will help you out.

-Minu

Hall of Fame Super Gold

Re: V WIC 1MFT G703 E1 CONTROLLER CARD

There is a difference,

Channel-group 1 timeslots 1-31 is framed at 1.984 Mbps.

Channel-group 1 unframed, is 2.048 Mbps.

On an unframed circuit you can use both.

Of course all the vwic cards supports data.

Hall of Fame Super Gold

Re: V WIC 1MFT G703 E1 CONTROLLER CARD

Another note, if you use "timeslots 1-31", you don't need the G.703 version of VWIC, but just the normal one, that is much less expensive.

The G.703 version is only needed when you absolutely need to support "unframed".

487
Views
5
Helpful
5
Replies
CreatePlease to create content