Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

V12.4 no service-module command or serial interfacd

I have new 2851 with 12.4. I installed a vwic 2mft-t/e1 card but can't configure. I don't have the service-module command of a serial interface, what am i mssing?

2 REPLIES
Hall of Fame Super Gold

Re: V12.4 no service-module command or serial interfacd

Darrell

Some of the documentation that I have looked at describes beginning by configuring controller e1 slot/port. Have you done the controller configuration? That may be required to see the serial interfaces (especially on a card that can do both voice application as well as data application)?

HTH

Rick

Community Member

Re: V12.4 no service-module command or serial interfacd

Hi,

Your probably going to need the command:

'card type t1 0 0' The 0 0 depends on what slot you have the card installed in I believe.

The the controller config will then show up.

113
Views
0
Helpful
2
Replies
CreatePlease to create content