I have a network as illustrated above. The modems are Comtech satellite modems; modem2 is internally clocked (DCE), modem1 is looptimed clocked(also DCE, but gets clock from modem2). The routers are DTE's. Essentially modem2 is the master clock for the setup.
Now my qeustion is, can one have two different interface types connected like this (R1=X21, R2=V35), without getting errors on the serial interfaces?
Presently, we get irregular bursts of loads of CRC errors on R2. We are looking at the satellite link, but i believe it might be due to the different interface types.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...