Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Verifying the QOS by Reserving bandwidth to a PC

Hi,

I need to limit bandwidth or Reserver bandwidth for a network, Eg:Iam having 1Mbps connection and there are two vlans

NetworkA

128 is for Voice

128 for Web

256 for  data

and

Network B

256 for Voice in this network

256 for data in this networkB

.So any network can use only the specified bandwidth as maximum  irrespective of congestion in the network or not.

I thought to use "Bandwidth" command to reserver required bandwidth for each network.But i read in documents that Bandwidth which is specifiedunder this command is used only when there is congestion.

Iam not able to use Rate-limit becuase i need to classify different traffic in NetworkA and reserver BW for each

How i can achieve this?

For testing i configured QOS for a specific PC by reserving only very less Bandwith using Police command but

Download and Upload speed is same Before QOS applied to WAN interface and after QOS applied.(that too speed is maximum)

Iam testing using  Speedtest.net in browser

Is my Testing is Right?

Why iam not getting limited Bw

1 REPLY

Re: Verifying the QOS by Reserving bandwidth to a PC

try downloading a file from web and limit your PC to use http traffic for x amount of low bandwidth. than try

Regards

Hitesh Vinzoda

166
Views
0
Helpful
1
Replies
CreatePlease to create content