I am trying to configure a vfi on my swicht ME-3600X. I want to have Ethernet Over MPLS multipoint-multipoint. That is why "xconnect" does not work for me. In my CORE with ASR9006 I configure the vfi like this:
interface gigabitethernet0/0/0/2.2 l2transport description enlace-per-bog-vlan-pw-2 encapsulation dot1q 2 rewrite ingress tag pop 1 symmetric exit interface gigabitethernet0/0/0/3.2 l2transport description enlace-per-bog-vlan-pw-2 encapsulation dot1q 2 rewrite ingress tag pop 1 symmetric exit l2vpn bridge group bg_mst_eje bridge-domain bd_mst-vlan-2 interface gigabitethernet0/0/0/2.2 interface gigabitethernet0/0/0/3.2 exit vfi vlan neighbor 10.248.10.1 pw-id 2
(I have to interfaces closing a l2 ring)
I want to know how I can configure something very similar on the ME-3600X. I am running "Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 12.2(52)EY2, RELEASE SOFTWARE (fc1)"
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...