Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VLAN enabling

Hi Folks,

While try to enaling sswitching/vlan am getting error

R1(config)#vlan ?

  accounting  VLAN accounting configuration

  ifdescr     VLAN subinterface ifDescr

am using 3640 verion os on GNS 3, Kindly suggest me ...

  • WAN Routing and Switching
2 REPLIES
Purple

VLAN enabling

Hi,

try this:

enable

vlan database

vlan 10

apply

exit

show vlan-sw brief  to verify

All this will only work if you've got a NM16-ESW switching module installed in slot 1

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

VLAN enabling

hi,

i just wanna add to what alain posted, to add the switch module in GNS3:

right click on the 3640 > configure > slots > select NM-16ESW > apply or just click OK.

also create the layer 3 SVI that will respond and route your layer 2 VLANs:

interface vlan x

ip address

122
Views
0
Helpful
2
Replies