Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VLAN IDs not showing up in 2960 switch configuration

We have Layer 2 2960 switches that all connect back to our 4500 core. the core has the Interface VLAN defs. But, in the access switches I can do a SHO VLAN and see all the VLANs in my network, but they do not show up in my running config. The guides all say to use the VLAN global command to define VLANs, but will just entering the switchport access vlan x put them in the VLAN database as well? We also do not have VTP defined. Any ideas?

1 REPLY
Hall of Fame Super Silver

Hello Kmattison,>> but will

Hello Kmattison,

>> but will just entering the switchport access vlan x put them in the VLAN database as well? 

yes this is correct. And it may explain what you see vlan entries in the vlan database without a corresponding vlan command in the running config.

 

Hope to help

Giuseppe

 

 

 

208
Views
0
Helpful
1
Replies