Second configuration port is defined as access port that is a member of VLAN 16. If you have other ports that are in this VLAN they all are essentially in the same broadcast domain - they can communicate with each other via layer 2. You would most likely be connecting a computer to this type of port.
In the first configuration the port is configured to be a trunk port with dot1q encapsulation. This port would be connected to another switch and frames would be tagged on egress. An example would be if switch 1 has ports in let's say VLAN 10 and 20 and switch 2 has ports in VLAN 10 and 20 you would trunk these VLANS over that port. The switch will tag the frame on egress so the switch on the other end of the trunk knows which VLAN the frame came from so the frame can be sent to the appropiate port(s) of the particular VLAN. the "switchport trunk native vlan" command tells the switch to send frames from that VLAN untagged.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...