Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Voice card issue - don't see ports even after configuring it.

Hi,

I don't see the voice card ports even after configuring it as follow:

Router(config)#card type t1 0 0

SURWAN(config)#voice-card 0

Router(config-voicecard)#codec complexity high

Router(config-voicecard)#dspfarm

Router(config)#controller T1 0/0/0

Router(config-controller)#framing esf
Router(config-controller)#linecode b8zs
Router(config-controller)#ds0-group 1 timeslots 1-24 type e&m-wink-start
%Configure network-clock-participate wic 0 first

after above configuration I don't see voice ports as in following commands:

Router(config-controller)#do sh voice port sum
                                           IN       OUT
PORT            CH   SIG-TYPE   ADMIN OPER STATUS   STATUS   EC
=============== == ============ ===== ==== ======== ======== ==

PWR FAILOVER PORT        PSTN FAILOVER PORT
=================        ==================

Router(config-controller)#exi


Router#sh ip int b
Interface                  IP-Address      OK? Method Status                Prot
ocol
GigabitEthernet0/0         10.10.10.1      YES NVRAM  down                  down

GigabitEthernet0/1         unassigned      YES NVRAM  administratively down down

GigabitEthernet0/2         unassigned      YES NVRAM  administratively down down

Serial0/1/0                unassigned      YES NVRAM  administratively down down

Serial0/1/1                unassigned      YES NVRAM  administratively down down

Serial0/1/2                unassigned      YES NVRAM  administratively down down

Serial0/1/3                unassigned      YES NVRAM  administratively down down

Router#sh voice port sum
                                           IN       OUT
PORT            CH   SIG-TYPE   ADMIN OPER STATUS   STATUS   EC
=============== == ============ ===== ==== ======== ======== ==

PWR FAILOVER PORT        PSTN FAILOVER PORT
=================        ==================

Please advise.

Thanks....

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Voice card issue - don't see ports even after configuring it

Hi,

I think the clue is right before our eyes:

Router(config-controller)#ds0-group 1 timeslots 1-24 type e&m-wink-start
%Configure network-clock-participate wic 0 first

You will need to add the network-clock-participate wic 0 global configuration command before entering the controller configuration and creating the timeslot groups.

Best regards,

Peter

1 REPLY
Cisco Employee

Re: Voice card issue - don't see ports even after configuring it

Hi,

I think the clue is right before our eyes:

Router(config-controller)#ds0-group 1 timeslots 1-24 type e&m-wink-start
%Configure network-clock-participate wic 0 first

You will need to add the network-clock-participate wic 0 global configuration command before entering the controller configuration and creating the timeslot groups.

Best regards,

Peter

361
Views
0
Helpful
1
Replies
CreatePlease to create content