Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

voice port configuration

Below is the partial configuration.

My Query is when 3/0/0 and 3/0/1 ports are busy with local calls (calls starting with non zero numbers), then the local calls should be established on 2/1/x which are configured for calls starting with '0'. This configuration is not working, needs modification. Pls help in this

dial-peer voice 210 pots

preference 8

destination-pattern 0[1-4,6-9][0-9]?

no digit-strip

direct-inward-dial

port 2/1/0

!

dial-peer voice 211 pots

preference 8

destination-pattern 00[1-4,6-9][0-9]?

no digit-strip

port 2/1/1

!

dial-peer voice 300 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/0

!

dial-peer voice 301 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/1

dial-peer voice 210 pots

preference 8

destination-pattern 0[1-4,6-9][0-9]?

no digit-strip

direct-inward-dial

port 2/1/0

!

dial-peer voice 211 pots

preference 8

destination-pattern 00[1-4,6-9][0-9]?

no digit-strip

port 2/1/1

!

dial-peer voice 300 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/0

!

dial-peer voice 301 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/1

dial-peer voice 210 pots

preference 8

destination-pattern 0[1-4,6-9][0-9]?

no digit-strip

direct-inward-dial

port 2/1/0

!

dial-peer voice 211 pots

preference 8

destination-pattern 00[1-4,6-9][0-9]?

no digit-strip

port 2/1/1

!

dial-peer voice 300 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/0

!

dial-peer voice 301 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/1

2 REPLIES
Hall of Fame Super Gold

Re: voice port configuration

Hi,

suggest that you configure all the ports that are connected to PSTN, in trunk-group. This will allow you to configure a single DP pots for each destinan-pattern, with said trunk-group as destination instead of port.

Once you do this the configuration is much reduced and so chances of error.

If still problems after that,please postif "IP Telephony" forum.

Hope this helps, pleaserate post if it does!

New Member

Re: voice port configuration

hi

u are geting this result because of wrong conf

put a dial-peer with destination pattern with 0 and atatch it port 2/1/x (also put preference 9 on the dial peer)

any for good sake use diffrent preferences on each dail-peer

plz rate this if u like

regards

109
Views
0
Helpful
2
Replies
CreatePlease login to create content