Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Voice QoS problems over a Point to Point. Cisco

Hello Everyone!

Before I start let me show you a diagram I have created that might help explain my situation and have attached it. My post is pretty long because I have included peices of configuration of each router/switch, so I have included a lot of it in the attached file.

Ok so this is my problem:

My users in the PTP 2 (the red PTP) are complaining that calls are cutting in and out on outbound calls. Not very often, but enough to make them complain. When I talk to them over the other point to point they say I cut in and out, but I hear them perfectly fine. I assume that other outside the network can hear them fine as well. On inbound calls they say everything is fine.

I should mention that I am new to cisco routers and new to this network. The only piece of this network I set up was the second point to point (the red one).

I would love if someone could point me in the right diection or go through some troubleshooting steps. Please let me know if you need more information.

1 REPLY
Hall of Fame Super Gold

Re: Voice QoS problems over a Point to Point. Cisco

No need for attachments. Just mention if you configured QoS on the circuit, or not.

Also good a idea would be to take guidance from a reputable professional, take no offense but you seem very fresh to networking to support business needs.

104
Views
0
Helpful
1
Replies