I attached my VoIP network image. Between site A and B I have Over The Air radio network. Red lan's means the ends of radio net. They have subnet, mask and gateway to the routers.For this radio net I must create a VLAN to carry traffic between routers, switches and radios, configure the gigabit ports of the switches connecting to the routers to trunk the VLAN(s), configure the switchports. On routers, create a sub-interface to accept the trunk from the switch, create RIP v2 router instance to collect routes from radionet, and distribute those routes with OSPF. Please help me with setting and CLI commands for routers (2900), switches (3560 V2 PoE-48) and UC 560 FXO K9.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...