guys, i have an mpls bet ny-uk,but my voip provider is a different one, i have a public ip given by my voip provider where i need to send traffic to, it is not working, should configure my 2811 with the public ip or my private ip.
I am trying to send voip traffice over the public internet,no p-to-p connection with my voip provider.
Could you be a bit more clear in what you are trying to do?
are you trying to do
Because if you are trying to use your MPLS to connect to your Internet VOIP Provider then that will not work unless you are getting fed an Internet route via the MPLS Cloud. You need to provide a bit more detail to get a correct answer.
I do have an internet feed via the MPLS,which happens to be fed by my same voip provider for another 2811/voip connection (this is totally seperate from my MPLS)the 2nd 2811 is phycally in the UK and it works fine, sending calls over the 10mb ethernet link bet my location and my voip provider in UK. I now have a 2811 here in NY,and i try to send traffic from the 2811 here using my MPLS.
I hope this gives you a more clear picture.
Note: I use the same FW and switch for my MPLS as well as for the 10mb ethernet for internet access.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...