Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

vpdn enable on 1721

Hi,

I'm getting my 1721 set up to connect via PPPOE and when I try to run the vpdn enable command I get this:

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#ip routing

Router(config)#ip subnet-zero

Router(config)#ip classless

Router(config)#end

Router#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#vpdn enable

^

% Invalid input detected at '^' marker.

Router(config)#

Is there a different command for this now?

TIA.

Jon

1 REPLY
VIP Purple

Re: vpdn enable on 1721

Hello Jon,

which IOS version are you running ? For VPDN, you need (with the IP Base feature pack) 12.3(16) -->

c1700-ipbase-mz.12.3-16.

Can you post the output of 'show version' ?

Regards,

GP

425
Views
0
Helpful
1
Replies
CreatePlease to create content