Did you try to use "ip policy route-map" command instead of "ip local policy route-map" ?
Where the "ip local policy route-map" command is for the packet which is originating from the router locally. And you can also check the ACL counter to ensure the packet is matched w/ the ACL, otherwise, it doesn't work. You also need to ensure the destination interface is correct. If you checked above but still not work, please post the full config for reference.
I found you apply the policy route-map at the dialer interface but one of the condition of the poicy is to set the next-hop to dialer 1. There is a conflict that the policy route-map should be applied to the incoming interface, e.g. local LAN interface, if the packet incoming from the local LAN interface then based on the policy to forward to the preferred next-hop ip or interface.
Could you tell which interface is the local interface ? Please advise the traffic flow, which is the incoming and which is the outgoing and under what condition to which interface ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.