Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPLS on 12000 series IOS

How to configure vpls on 12000 series. i can able to create l2 vfi name manual etc

how to apply on vlan interface.I didnt see int vlan command to apply xconnect vfi . please help.The same issue on ASR 1004 also

3 REPLIES
Hall of Fame Super Silver

Re: VPLS on 12000 series IOS

Hello Pramod,

GSR 12000 and ASR 1000 are routers:

commands have to applied to:

main interfaces or subinterfaces there are no SVIs here only L3 interfaces and subinterfaces.

Hope to help

Giuseppe

New Member

Re: VPLS on 12000 series IOS

Hi Giuseppe,

But i didn't find command xconnect vfi command on subinterface/maininterface of router

Re: VPLS on 12000 series IOS

An 'xconnect' command is not used when configuring VPLS on the GSR. Please have a look at the following document about configuring VPLS on the GSR:

http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/vpls_qos.html#wp1038114

Also, you should probably have a look at the limitations/restrictions:

http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/vpls_qos.html#wp1025005

and the supported ISE linecards and SPAs:

http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/vpls_qos.html#wp1025011

The limitations/restrictions are plenty, so you probably need to test and/or contact cisco to address the requirements of your specific environment.

p.s. I can't help with the ASR 1000, but I think somebody replied to another conversation that you opened about this platform.

269
Views
5
Helpful
3
Replies