i seem to have an issue with my GW to GW setup between my 2 x Cisco RV320’s (one at home and one in the office). The tunnel is up and it always stays connected but I can’t connect to devices from either when I could before. My office RV320 does have a LAN to LAN IPSec Tunnel to a Draytek router and that seems fine.
If I reboot my home RV320 I can connect back to the office ok but this only lasts for about 2 min and then it goes again. Has anyone got and ideas? The one thing that has change is I have a new internet service, the firewall is the same from when it worked, it’s on the lastest firmware and the router for the new internet has turn of the ACL that Denys any access.
its strange as it was working and not I can’t get it back up
Hell all, thank you for the replies. Yes the firmware at both ends is as mentioned above on the latest release.
i have done some further testing and this is what I have found. I can access my home network from work fine but from home to the office is still a problem. Could this link in with VPN Passthrough option mentioned above?
could this also be a routing issue? I do have at the work end three separate networks running of this Rv320
192.168.1.0, 192.168.2.0 and 192.168.3.0 each on a separate VLAN which I could access before. The GW To GW cover the above range, so do I need to tell the router of this IP range via any routing
I'm working on a project that includes basic router configurations. I configurated everything including: line console 0, line vty 0 15 and secret passwords. There are 3 routers in the network and every LAN is going t...
Desire to create Terminal Server ("TS" in this document) out of 2811 Cisco Router with HWIC-16A card (with Octal cables)
Desire to use SSH over Telnet
TS is ip'ed, SSH access configured (to the TS)
Python based Script to BULK Import/Delete devices using Cisco Prime API
Check my Repo on GitHub for all the details ( see below link )