I already have 4 basic ipsec vpn tunnels with the same service provider over 1.5m dsl connections with small 871's connecting to a full T1 on an 1841 router at corp using the SDM gui - site to site vpn. Problem is, we just purchased 3 more sites and Im trying to set up 3 more vpns. I have tried to build, troubleshoot, rebuild, called the ISP, etc and cannot get them to traverse traffic AT ALL. The VPN tunnel shows "connected" on all three.. but I cannot ping from on wan interface to the other - weather internal or external. The remote sites are able to get on the web, etc. I will post the corp router setup as well as a remote. I am dying here - if anyone can give any advice, I would be greatly in debt.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...