I am looking for the correct IOS to install on my 2811 so I can set up vpn groups, much like you would with a PIX for remote employees running the Cisco VPN Client software.
I have done this on a Pix 525 and 506e, but the company I work for today does not have a PIX, they employ a Juniper firewall and Juniper SSL device. I am creating a backdoor in the event the firewall dies and we cannot route internally remotely to gain cli access to bring the firewall back up. What I have to work with is a 2811 so any help would be appreciated.
I am basically trying to set up the same type of set-up on the 2811 that I would have done on the PIX525 by creating a vpn user group, assigning an address-pool and building an acl to allow access to the needed resources.
To mirror a replication of being on the network, with the ability to map drives, etc...
I have done this in a PIX just never on the router.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...