Would like to know whether using an HSRP standby IP is a valid source interface for VTI. We’ll have 2 ASR 1001 routers at the hub site running HSRP, and VTI tunnels to the spoke sites. Would like to maintain VTI in the event of a switchover to standby router. Is this possible, or do I have to maintain two distinct tunnels and use a dynamic routing protocol to re-route traffic that way? Thanks
I've read in a blog post that VTI sourced from a virtual IP address wasn't supported, but the post was 5 years old. I haven't been able to find a definitive answer to the question, one way or the other though.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...