06-12-2006 12:53 PM - edited 03-03-2019 12:58 PM
Hi,
I?ve configured vtp pruning but I am still getting broadcast traffic from vlan 6. I just used the vtp pruning command. Do I have to configure anything else to enable pruning?
Thanks
06-12-2006 01:01 PM
hi,,,
will you clear it in more detail with your connectivity...and problem ...
here you are receiving the broadcast traffice of vlan 6 of one switch to other which is not having the vlan 6 am i right???
06-13-2006 07:53 AM
I?ve a 3550,routing between vlan?s. I?ve configured span to monitor one of the fiber ports and I am receiveing broadcast from computers in vlan6. Should I receive this type of traffic?
3550---------------vlan6
| |
fiber |
| | |
| ---vlan8------- vlan7
|
vlan1
|
|
vlan1
06-13-2006 08:06 AM
It got a little confused, but I?ve a dual ring topology among vlan?s 6,7 and 8 connected through fiber.
06-12-2006 01:13 PM
you can have more information form the given link
http://www.firewall.cx/vlans-vtp-pruning.php
rate this post if it helps
regards
Devang
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: