Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VTP Pruning

Hi,

I?ve configured vtp pruning but I am still getting broadcast traffic from vlan 6. I just used the vtp pruning command. Do I have to configure anything else to enable pruning?

Thanks

4 REPLIES

Re: VTP Pruning

hi,,,

will you clear it in more detail with your connectivity...and problem ...

here you are receiving the broadcast traffice of vlan 6 of one switch to other which is not having the vlan 6 am i right???

Community Member

Re: VTP Pruning

I?ve a 3550,routing between vlan?s. I?ve configured span to monitor one of the fiber ports and I am receiveing broadcast from computers in vlan6. Should I receive this type of traffic?

3550---------------vlan6

| |

fiber |

| | |

| ---vlan8------- vlan7

|

vlan1

|

|

vlan1

Community Member

Re: VTP Pruning

It got a little confused, but I?ve a dual ring topology among vlan?s 6,7 and 8 connected through fiber.

Re: VTP Pruning

you can have more information form the given link

http://www.firewall.cx/vlans-vtp-pruning.php

rate this post if it helps

regards

Devang

121
Views
4
Helpful
4
Replies
CreatePlease to create content