Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VTP Pruning

Hi,

How to configure VTP Pruning.Any advantages by configuring this.

Pls help

regds

Nasheer

2 REPLIES

Re: VTP Pruning

HI Nasheer, [Pls Rate if HELPS]

VTP pruning causes information about each pruning-eligible VLAN to be removed from VTP updates if there are no stations belonging to that VLAN out a particular switch port. Use the set vtp command to enable VTP pruning.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_4_2/config/vlans.htm#xtocid798016

Do Rate if HELPS

Best Regards,

Guru Prasad R

Re: VTP Pruning

The link given by Gurubhai is for configuration on catalyst. If you are searching for IOS switches, here it is:

http://www.cisco.com/en/US/docs/routers/7600/ios/12.2SXF/configuration/guide/vtp.html#wp1032282

This is generally done for optimal use of the trunk. The trunk carries info for all vlans. If there are no hosts for a specific VLAN on the switch connected to trunk, then the traffic for that vlan across trunk is unnecessary. So pruning helps the switch by not sending the unnecesary info on to the trunk.

Refer this link for understanding:

http://www.firewall.cx/vlans-vtp-pruning.php

hope that helps.

pls rate all helpful posts.

689
Views
0
Helpful
2
Replies