Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VWIC-1MFT-E1 and ATM / IMA

Hi,

I have a Cisco 2600 Router (IOS 12.3 (13a) with an installed VWIC-1MFT-E1 running. Now I try to connect this to a DSLAM with an IMA module, an Adtran Total Access 1200 with a Quad IMA module.

I want to get an ATM link from the DSLAM to the 2610, just using a single E1 link. Means I don´t need the IMA capabilities, I could just use "Pass through" mode for that single E1 link ?

I set the E1 controller with "mode atm" into ATM mode. So there should be an ATM interface configurable now, is that correct ? Bute there is no ATM interface appearing.

The DSLAM tells me that the E1 link is working, but the IMA module not in sync.

Does anyone have an idea ? Any comments or sample configs ?

I highly appreciate your help.

Regards,

Christian Manthey

1 REPLY
New Member

Re: VWIC-1MFT-E1 and ATM / IMA

Or maybe I need the IP Plus feature set in order to get this running ?

116
Views
0
Helpful
1
Replies
CreatePlease login to create content