Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

VWIC-1MFT-G703 and 2mb Leased Line

Hi,

We have a customer that has a Leased line provided by BT in the UK.

Each site has a Cisco 2650xm and VWIC-1MFT-G703 cards, The line was a 1Mb connection but has been upgraded to 2Mb.

The current config has the following lines.

controller E1 0/0

line-termination 75-ohm

channel-group 1 timeslots 1-16

I belive that I need to change the time slot to get the full bandwidth? is this correct. I have tried this morning to change the time slots to 1-31 but the line protocol stays down(I did change at both ends)

Any help on this matter would be great.

Regards,

Simon.

1 REPLY

Re: VWIC-1MFT-G703 and 2mb Leased Line

Hi

In addition to altering the timeslots which is required for E1 have you tried changing or configuring the framing parameter ?

it can be configured using the cli - framing no-crc4.

do configure this up and check whether you get the link up or not..

regds

196
Views
0
Helpful
1
Replies
CreatePlease to create content