Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VWIC-1MFT-G703= not working with framerealy encaplsulation

Dear all

Cisco 1841 router with VWIC-1MFT-G703 card , old cards getting error , so we planned replace new VWIC-1MFT-G703 , its detecting but line protocol was down , than we changed another cards also same status ,

Physical loop given ( PIn out 1 and 4 2 and 5 ) , both cards show line protocol up ( looped)

Please suggest any modification required in configuration side ,  Slot 0 ( OLD card ) Slot 1 - New Card

WIC/HWIC Slot 0:
E1 G703 (1 port) Multi-Flex Trunk WAN daughter card
Hardware revision 1.0          Board revision A0
Serial number     36621247   Part number    800-06722-04
Version Identifier     V02  FRU Part Number     VWIC-1MFT-G703   
Test history      0x0          RMA number     00-00-00
Connector type    PCI
EEPROM format version 1
EEPROM contents (hex):
   0x20: 01 2F 01 00 02 2E CB BF 50 1A 42 04 00 00 00 00
   0x30: 50 00 00 00 08 08 18 00 FF FF FF FF FF FF FF FF

WIC/HWIC Slot 1:
E1 G703 (1 port) Multi-Flex Trunk WAN daughter card
Hardware revision 1.0          Board revision E0
Serial number     33597427   Part number    800-06722-02
FRU Part Number     VWIC-1MFT-G703=  
Test history      0x0          RMA number     00-00-00
Connector type    PCI
EEPROM format version 1
EEPROM contents (hex):
   0x20: 01 2F 01 00 02 00 A7 F3 50 1A 42 02 00 00 00 00
   0x30: 70 00 00 00 05 05 26 00 FF FF FF FF FF FF FF FF

2 REPLIES
Bronze

Re: VWIC-1MFT-G703= not working with framerealy encaplsulation

Hi Siva,

Have you tried in another slot?

It does not look like hardware issue.

The following troubleshooting guide for FR may help you out....

http://www.cisco.com/en/US/tech/tk713/tk237/technologies_tech_note09186a008014f8a7.shtml

Regards...

-Ashok.

With best regards... Ashok ----------- Pls kindly rate if helpful or answered your question.
New Member

Re: VWIC-1MFT-G703= not working with framerealy encaplsulation

Hi,

we tried three new card  same status , 3 card are view in show diag command , but line protocol down , same slot Old is working with errors.

Physical loop  -- > it Line Protocol UP ,, ( after remove the Frame-relay encapsulation ) ,

580
Views
0
Helpful
2
Replies