Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VWIC-2MFT-E1-DI always with slips.. broken? Know bug?

Hi, I have the 2 port VWIC card and one of the ports is always detecting slips seconds and errored seconds when the clock is on line, I think may be I must change the card but I don't know if there's a buf related to that.

Model 1841

flash:c1841-spservicesk9-mz.124-17.bin

Card

WIC/HWIC Slot 0:
        E1 (2 port) Multi-Flex Trunk (Drop&Insert) WAN daughter card
        Hardware revision 1.0           Board revision B0
        Serial number     30199770      Part number    800-04615-03
        FRU Part Number     VWIC-2MFT-E1-DI=
        Test history      0x0           RMA number     00-00-00
        Connector type    PCI
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 25 01 00 01 CC CF DA 50 12 07 03 00 00 00 00
          0x30: 58 00 00 00 03 03 12 00 FF FF FF FF FF FF FF FF

config

!
controller E1 0/0/1
channel-group 1 timeslots 1-31
!
!

State

E1 0/0/1 is up.
  Applique type is Channelized E1 - balanced
  No alarms detected.
  alarm-trigger is not set
  Version info Firmware: 20070320, FPGA: 20, spm_count = 0
  Framing is CRC4, Line Code is HDB3, Clock Source is Line.
  CRC Threshold is 320. Reported from firmware  is 320.
  Data in current interval (301 seconds elapsed):
     0 Line Code Violations, 0 Path Code Violations
     301 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
     301 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
  Total Data (last 1 15 minute intervals):
     0 Line Code Violations, 0 Path Code Violations,
     900 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
     900 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
CS_BGP001M0#

Thank's in advance

Regards

1 REPLY
Hall of Fame Super Gold

Re: VWIC-2MFT-E1-DI always with slips.. broken? Know bug?

Configure:

network-clock-select 1 e1 0/0/1

450
Views
0
Helpful
1
Replies