12-01-2009 12:07 PM - edited 03-04-2019 06:51 AM
folks
i have a point to point serial link (2mb) which my provider has recently installed
i had my routers, a 2821 & and 1841, configured with wic2t cards installed and the standard cables (smart serial with an x.21 at the other end)
however the provider now tells me i need a vwic2-1mft-g703 card at each end rather than the wic2t
i'm looking for a configuration guide and a cable specification, i.e. will cat5 ethernet link from the providers NTE to my vwic
the link is purely data, no voice
can anyone point me in the direction of a configuration guide for a simple point to point link over vwic2-1mft-g703
thanks to anyone taking the time to read this or contribute
greatly appreciated
Solved! Go to Solution.
12-07-2009 04:28 AM
Hi,
If you can't see the controller, probably the card is not being detected. Please attach a "show ver", "show run" and "show diag" here so that I can go through them.
12-01-2009 12:26 PM
Here's the sample configuration we may use in this scenario
controller E1 3/0
channel-group 0 unframed
!
interface Serial3/0:0
ip address 40.0.0.1 255.255.255.0
You would have a controller already in the configuration. Once you can see the controller, you can go into the controller configuration mode and configure the channel-group as shown above. This would create a serial interface which you can configure just the way you would using a WIC-1T
Here's configuration document for this card
http://www.cisco.com/en/US/docs/ios/12_1t/12_1t1/feature/guide/dtg703.html
Hope this helps
12-02-2009 01:07 PM
ronit
many thanks for your reply, its gratefully appreciated
i've tried the config commands on my routers, an 1841 & a 2821 but there is no controller command
i've looked for the relevant command reference guide but i can't find the command
can you point me in the right direction please?
thanks
12-07-2009 04:28 AM
Hi,
If you can't see the controller, probably the card is not being detected. Please attach a "show ver", "show run" and "show diag" here so that I can go through them.
12-08-2009 12:57 AM
ronit
many thanks again for your help
i hadn't installed the card so i thought i needed an ios upgrade
once i installed the card i could configure the controller and the interface
again, thank you
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: