Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

vwic2-1mft-g703

folks

i have a point to point serial link (2mb) which my provider has recently installed

i had my routers, a 2821 & and 1841, configured with wic2t cards installed and the standard cables (smart serial with an x.21 at the other end)

however the provider now tells me i need a vwic2-1mft-g703 card at each end rather than the wic2t

i'm looking for a configuration guide and a cable specification, i.e. will cat5 ethernet link from the providers NTE to my vwic

the link is purely data, no voice

can anyone point me in the direction of a configuration guide for a simple point to point link over vwic2-1mft-g703

thanks to anyone taking the time to read this or contribute

greatly appreciated

1 ACCEPTED SOLUTION

Accepted Solutions

Re: vwic2-1mft-g703

Hi,

If you can't see the controller, probably the card is not being detected. Please attach a "show ver", "show run" and "show diag" here so that I can go through them.

4 REPLIES

Re: vwic2-1mft-g703

Here's the sample configuration we may use in this scenario

controller E1 3/0
channel-group 0 unframed
!
interface Serial3/0:0
ip address 40.0.0.1 255.255.255.0

You would have a controller already in the configuration. Once you can see the controller, you can go into the controller configuration mode and configure the channel-group as shown above. This would create a serial interface which you can configure just the way you would using a WIC-1T

Here's configuration document for this card

http://www.cisco.com/en/US/docs/ios/12_1t/12_1t1/feature/guide/dtg703.html


Hope this helps

New Member

Re: vwic2-1mft-g703

ronit

many thanks for your reply, its gratefully appreciated

i've tried the config commands on my routers, an 1841 & a 2821 but there is no controller command

i've looked for the relevant command reference guide but i can't find the command

can you point me in the right direction please?

thanks

Re: vwic2-1mft-g703

Hi,

If you can't see the controller, probably the card is not being detected. Please attach a "show ver", "show run" and "show diag" here so that I can go through them.

New Member

Re: vwic2-1mft-g703

ronit

many thanks again for your help

i hadn't installed the card so i thought i needed an ios upgrade

once i installed the card i could configure the controller and the interface

again, thank you

1317
Views
0
Helpful
4
Replies