I have a 2921 router, with UCK9 services on it. I've installed a VWIC2-2MFT but the system is not seeing it. I've been told there is a command required to enable the card, is this true? If so, can anyone point me in the right direction with regards to the command? I've always done most of my UC work on the 2800 range and never had to run an enable command, it just saw the card.
Thanks for your replies. I've been having several discussions onsite where I am with other engineers. It looks like I was given false advice and there is no additional command (I had already added the card type command, hence why I was confused it didn't work). After some further investigation it looks like I've got a faulty VWIC so I'm going to replace the card.
The router will not take the card type command, show inventory does not see the card. I've tried the card in another, brand new chassis and it does not work in that either. I have tried a new card and this now works fine. It was the wrong advice I was given by an engineer onsite this end, that threw me and pushed me to ask the question on the support forum, as I had searched high and low for an additional command required......which I have now realised doesn't exist.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.