I am carrying out some test on WAAS for a client,every configuration seems okay.
The Edge WAE is stuck on the offline state,though i have done cms enable on the edge WAE,and network connectivity is ok-i can ping and even telnet to it,it can also ping both the central manager and the Core WAE.
What could be the problem,any other additional configurations that i should put in to resolve this.
- To activate all inactive WAEs, click the "Activate all Inactive WAEs" icon.
- Select Create a new location for each inactive WAE, then click Submit.
- Click the Devices tab, then click Refresh Table Icon to verify that all of the WAEs are online. You may have to wait a few minutes before the status change to "Active". Click Refresh Table several times until becomes Active.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...