Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

waas inline problem

I cannot get inline adapter to work, on wae-512. lan port of inline groups is admin down

was#sh int inlineport 1/0/lan
Device name        : eth5. Bypass slave interface.
Packets Received   : 0
Packets Intercepted: 0
Packets Bridged    : 0
Packets Forwarded  : 0
Packets Dropped    : 0
Packets Received on native      : 0
Active flows for this interface : 0

Ethernet Driver Status
-------------------------
Type:Ethernet
Ethernet address:00:E0:ED:10:D0:B7
Maximum Transfer Unit Size:1500
Metric:1
Packets Received: 0
Input Errors: 0
Input Packets Dropped: 0
Input Packets Overruns: 0
Input Packets Frames: 0
Packet Sent: 0
Output Errors: 0
Output Packets Dropped: 0
Output Packets Overruns: 0
Output Packets Carrier: 0
Output Queue Length:1000
Collisions: 0
Base address:0x40c0
Flags:BROADCAST MULTICAST
Link State: Interface is administratively down, line protocol down
Mode: autoselect
was#

2 REPLIES
New Member

Re: waas inline problem

I have this same problem... where you able to solve this issue?  My interface is on a trunked interface.

New Member

Re: waas inline problem

you must have connected and alive both ports in grou

p, wan and lan. In my case error was that I connected only wan port.

bye

613
Views
0
Helpful
2
Replies