I am trying to install two Serial 2T cards into a 3745 router (R3 in this diagram), all with smart cables to its neighbor. All the devices involved are in one room. One card has no problem with finding its two CDP neighor. The other, which i am trying to set as Frame-relay connections to others, connected to another 3745 that is used as Frame-relay switch.
R2==Serial port on WIC 2====R3=====Serial port on WIC 1(problematic link)==Frame Switch(3745 similated)======R1
|=====Same card ===============================|
Problem: Interface on R3 to Frame Switch is alway up/down, when configured with Frame-relay encapsulation(the same linke, when I set it as hdlc on both sides, it works fine. ). But R1 and R2 are working fine. they are same routers, cards.
Anyone can give me some hint? It seems that there is no much documents online for this.
Also, a second question, the numberation of the ports seems to be very confusion, it doesnt go with the physical slots.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...