Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

wan interface card configuration problem

hi,

we are using 2821 router with 1 NM-2CE1T1-PRI in slot 1 and 1 VWIC-2MFT-E1 card in HWIC 0 slot.the problem is that router is not taking the card type e1 0/card type e1 2 command.i have to configure 1 2MB link with unframed command on VWIC-2MFT-E1 card.router is taking card type e1 1 command on NM-2CE1T1-PRI(slot 0).pls suggest us what to do.

4 REPLIES
New Member

Re: wan interface card configuration problem

Parba,

I believe on the VWIC cards you do not have to specify card type. Instead you configure the 'controllers' first. Afterwards the physical interfaces will show up in the config:

controller e1 0/0

!

interface s0/0:x

HTH,

Jarred

New Member

Re: wan interface card configuration problem

thanks a lot, i will check this...

Hall of Fame Super Gold

Re: wan interface card configuration problem

Hi,

VWIC-2MFT-E1 does no support unframed operation.

For that, you will need VWIC-xMFT-G703 or VWIC2-xMFT-G703.

Hope this helps, please rate post if it does!

New Member

Re: wan interface card configuration problem

thanks a lot...

124
Views
0
Helpful
4
Replies
CreatePlease to create content