I have purchased a /27 WAN IP,and i constructed a tunnel with one of the IP other than the gateway IP.Theoretically the tunnel should work with out Route, but now in my case it is not working.I Wanna to route all tunnel (IPSec) traffic to the Gatway IP of My wan Network..
128.x.x.1 ---WAN Gateway IP
128.x.x.3--- Interface IP of Tunnel.
Can any one help me to understand this some more better
Would you mind giving us more precise information? We need to know your current configuration and the exact method you have used to diagnose whether the tunnel works or not. The more information about your current configuration and your ISP connection we know the better.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...