Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

WAN Link error

we have the following coming up on the router. Please what does this all mean and what next should I do?

Thanks

Nov 30 02:34:26 GMT: %CONTROLLER-5-UPDOWN: Controller x.x, changed state to down (RAI detected)

Nov 30 02:34:28 GMT: %LINK-5-CHANGED: Interface Serialx.x, changed state to reset

Nov 30 02:34:28 GMT: %BGP-5-ADJCHANGE: neighbor x.x.x.x Down Interface flap

Nov 30 02:34:28 GMT: %CONTROLLER-5-UPDOWN: Controller x.x, changed state to up

Nov 30 02:34:29 GMT: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serialx.x changed state to down

Nov 30 02:34:30 GMT: %LINK-3-UPDOWN: Interface Serialx.x, changed state to up

Nov 30 02:34:32 GMT: %CONTROLLER-5-UPDOWN: Controller x.x changed state to down (AIS detected)

Nov 30 02:34:34 GMT: %LINK-5-CHANGED: Interface Serialx.x, changed state to reset

4 REPLIES
Silver

Re: WAN Link error

Hi ,

I think controller on the router has some problem...

Channelised E1 has some problem . I mean it is not constant and fluctuating a lot...

Check with your service provider and if possible take the loop tests...

"sh controller e1 XXX " output can help us in resolving your issue.

Thanks,

satish

Community Member

Re: WAN Link error

Thanks.

I have done a show controller. What should I be looking for, what should it be telling me?

Thanks

Community Member

Re: WAN Link error

hai,

I suspect the issue is there in Link ......alarm indicates (AIS --alarm indication singnal ..and RAI Remote alarms )

Pls check with ;your service provider

(AIS detected)

(RAI detected)

Community Member

Re: WAN Link error

Thanks

209
Views
0
Helpful
4
Replies
CreatePlease to create content